Connect The Latch Bar Assemblies To The Latch Bar; Install The Door Latch Rod; Install The Winch Anchor Bracket - Ferris SNAPPER PRO EZ Dump Operator's Manual

32
5. Using the clevis pin and cotter pin (D) connect the clevis
(E) to the slot in the latch bar assembly (F).
6. Install a left hand threaded nut (D, Figure 31) and a left
hand threaded ball joint (E) onto the left hand threaded
end of the 5/16 X 7" threaded rod if you are working on a
12 cu. ft. hopper (A) or 5/16 X 10-1/4" threaded rod (B) if
you are working on a 14 cu. ft. hopper.
7. Install a right hand threaded nut (F) and a right hand
threaded ball joint (H) onto the right hand threaded end of
the 5/16 X 7" threaded rod if you are working on a 12 cu.
ft. hopper (A) or 5/16 X 10-1/4" threaded rod (B) if you are
working on a 14 cu. ft. hopper.
8. Using two (2) 5/16-18 X 1-1/4" bolts and 5/16-18 hex
nylon lock nuts (A, Figure 32) connect the rod assembly
(G) to the handle mount (H) and the shorter arm of the
pivot mount block (I).
9. Make sure that the dump handle is positioned in the
CLOSED slot (J) of the bracket and adjust the overall
length of the rod as necessary to install it. The jam nuts
can be left loose at this time as it will be necessary to
adjust the length of the rod later.
Connect the Latch Bar Assemblies to the
Latch Bar
1. Using a clevis pin and cotter pin (A, Figure 33) connect
the clevis end of the latch bar assemblies (B) into the
front hole of the hopper latch bar (C).
33

Install the Door Latch Rod

1. Install the door latch rod (A, Figure 34) onto the hopper
door latch (B) and the dump handle (C) and secure both
ends using a 3/8" clevis pin (D), 3/8 SAE washer (E) and
secure using a 1/8 X 3/4" cotter pin (F).
34

Install the Winch Anchor Bracket

1. Mount the winch anchor bracket (A, Figure 35) to the
inside of the left support plate (B) with two (2) 5/16-18
15