Install the Handle on the Winch
1. Install the backing plate (A, Figure 39) and winch handle
(B) onto the winch handle shaft (C) and secure using a
1/2-13 hex nylon lock nut (D).
39
Install the Hopper to the Hopper Mount
1. Position the pivot pins of the mount tube (A, Figure 40)
into the slots of the hopper mount (B).
40
2. Place the winch and mount assembly (C) into the tube of
the winch quick mount (D).
WARNING
The winch included with this hopper kit is intended for the
sole purpose of mounting and removing the hopper from the
zero-turn riding mower and is not intended to be used for
any other purpose.
3. Place the winch lock lever in the middle position (A,
Figure 41), this will release the lock on the winch and
allow you to pull the winch hook (E, Figure 40) to the
hopper.
41
17