Table of Contents
Advertisement
S200XT with 61" Mower Deck (12 cu. ft. Hopper)
17
1. Position the hopper mount plate (A, Figure 17) onto the
bumper (B) and route four (4) 3/8-16 X 1" bolts (C) and
3/8 flat washers (D) through the holes identified as "A" in
Figure 18 and then through the bumper and secure with
four (4) 3/8 hex nylock flange nuts (E).
18
2. Route two (2) 3/8-16 X 1" bolts and 3/8 flat washers
through the holes identified as "B" in Figure 18 and then
through the bumper and secure with two (2) 3/8 hex
nylock flange nuts.
3. Route one (1) 3/8-16 X 1" bolt and a 3/8 flat washer
through the hole identified as "C" in Figure 18 and then
through the bumper and secure with one (1) 3/8 hex
nylock flange nut.
10
S200XT with 61" Mower Deck (14 cu. ft. Hopper)
19
1. Position the hopper mount plate (A, Figure 19) onto the
bumper (B) and route four (4) 3/8-16 X 1" bolts (C) and
3/8 flat washers (D) through the holes identified as "A" in
Figure 20 and then through the bumper and secure with
four (4) 3/8 hex nylock flange nuts (E).
20
2. Route two (2) 3/8-16 X 1" bolts and 3/8 flat washers
through the holes identified as "B" in Figure 20 and then
through the bumper and secure with two (2) 3/8 hex
nylock flange nuts.
3. Route two (2) 3/8-16 X 1" bolts and 3/8 flat washers
through the holes identified as "C" in Figure 20 and then
through the bumper and secure with two (2) 3/8 hex
nylock flange nuts.
Install the Stabilizer Straps (Models with
Flat Plate Bumpers)
Models with flat plate bumpers utilize stabilizer straps to help
mount the hopper mount plate to the unit. Each series, deck
size, and hopper combination has it's own specific stabilizer
straps and unique orientation. Your kit only has the stabilizer
straps for the machine the hopper kit that was purchased was
intended to be installed on.
ferrismowers.com | snapper.com
Advertisement
Table of Contents
