Amana MMW-2 Installation Manual

Installation Manual
An.ono·
MMW-2
Thermostat Application Guide
Description
Gas or Oil Heat
Electric Furnace
Heat Pump ( No Aux. or Emergency Heat)
Heat Pump (With Electric Aux.)
Heat Pump (With Gas Aux.)
Multi-Stage Systems
Heat Only Systems - Floor or Wall Furnace
Cool Only Systems
High and Low Fan Speed
Millivolt
Emergency Heat
Conventional Single Stage Furnace
Geothermal
Table of Contents
Installation Tips
Thermostat Quick Reference
Wiring
Wiring Diagrams
Technician Setup
Swing Setting
Specifications
PTAC DIRECT SALES, INC.
185 S. KIMBALL AVE., SUITE 130
SOUTHLAKE, TX 76092
0
877.454.7822
Installation Tips
Mount Thermostat
Align the 4 tabs on the subbase with corresponding slots on the back
of the thermostat, then push gently until the thermostat snaps in place.
LOW...J I LHtGH
Battery Installation
Battery installation is optional if thermostat is
hardwired (Rand C terminal connected to 24V
power).
Important:
High quality alkaline batteries are recommended.
Rechargeable batteries or low quality batteries
do not guarantee a 1-year life span.
Insert 2 AAA
Alkaline batteries
(included). High
quality alkaline
batteries are
recommended.
Power Type
Battery Power
Hardwire (Common Wire)
Yes
Hardwire (Common Wire) with
Yes
Battery Backup
Yes
Yes r
No A trained, experienced
No
technician must install this
Yes
product.
Yes
Carefully read these
Yes
No instructions. You could damage
No this product or cause a
Yes
hazardous condition if you fail
Yes
to follow these instructions.
page
Una version en espanol de este'
2-3 manual se puede descargar en
la pagina web de la compafiia.
4
5-6
7-8
9 - 10
11
12
r --r
oc
-in°F
,u
Room
6-!;
Cl
<J)
FAN SYSTEM
COOL ...J I L HEAT
AUTO OFF
Wall Locations
The thermostat should be installed approximately 4 to 5 feet
above the floor. Select an area with average temperature and
good air circulation.
4f
Installation Tip
;;
Pick an installation location that Is easy for
the user to access. The temperature of the
location should be representative of the
building.
Subbase Installation
G) Horizontal Mount
@Vertical Mount
@
�2
I
�/
For vertical mount put one screw on the top
and one screw on the bottom.
For horizontal mount put one screw on the
left and one screw on the right.
Getting to know your thermostat
p
'
,/
,u
'°°'"
?' F ;(1° F
-
-
6J;
�
Cl
FAN
SYSTEM
LOWQHl<ll-l
i
COO�EAT
AUTO OFF -
1 2
•'-
/
<D LCD
@ Fan Switch
@ System Switch
© Setpoint Buttons
Installation Tips
Do not install
thermostat in locations:
• Close to hot or cold air ducts
• That are in direct sunlight
• With an outside wall behind
the thermostat
• In areas that do not require
conditioning
• Where there are dead spots
or drafts
(in corners or behind doors)
• Where there might be
concealed chimneys or
pipes
�
• Installation Tip:
= Electrical Hazard
Failure to disconnect the power before
beginning to install this product can
cause electrical shock or equipment
damage.
!
Mercury Notice
All of our products are mercury free.
However, if the product you are
replacing contains mercury, dispose of
it properly. Your local waste
management authority can give you
instructions on recycling and proper
disposal.
Thermostat Quick Reference
Indicates the Displays the user
current room selectable setpoint
temperature. temperature.
System operation
Low attery Indicator:
Indicators: On will
Replace batteries when
display when the
indicator is shown.
COOL or HEAT.
�
0