Advertisement
Quick Links
WIRELESS THERMOSTAT KIT (DSA01NM)
Thermostat
ATTENTION INSTALLING PERSONNEL
As a professional installer you have an obligation to know the
product better than the customer. This includes all safety
precautions and related items.
Prior to actual installation, thoroughly familiarize yourself
with this Instruction Manual. Pay special attention to all
safety warnings. Often during installation or repair it is
possible to place yourself in a position which is more
hazardous than when the unit is in operation.
Remember, it is your responsibility to install the product
safely and to know it well enough to be able to instruct a
customer in its safe use.
Safety is a matter of common sense...a matter of thinking
before acting. Most dealers have a list of specific good
safety practices...follow them.
The precautions listed in this Installation Manual are in-
tended as supplemental to existing practices. However, if
there is a direct conflict between existing practices and the
content of this manual, the precautions listed here take
precedence.
RECOGNIZE THIS SYMBOL
AS A SAFETY PRECAUTION.
9/2015
IO-908A
Due to policy of continued product improvement, the right is reserved to change specifications and design without notice.
PTAC
I
NSTALLATION
A
Heating & Air Co nditioning
®
5151 S an Felipe, S uite 500 • Houston, TX 77056
www.amana-ptac.com
©
Copyright 2015
is a registered trademark of Maytag Corporation or its related companies and is used
under license to Goodman Company, L.P., Houston, TX, USA. All rights reserved.
I
NSTRUCTIONS
Radio - Non Mesh
The following installation instructions are for a typical
installation.
Please contact your PTAC salesperson for additional assis-
tance and explanation prior to ordering materials or cutting
openings.
1.
ANTENNA INSTALLATION FOR DSA01NM KIT
An antenna must be installed on the digital PTAC to allow
DSA01NM
operation of the
PREPARATION
1. Disconnect power to the unit by unplugging the power
cord at the wall outlet or subbase, or disconnect power
at the fuse box or circuit breaker.
2. If the cabinet front is screwed to the chassis, remove
the 1/4" screw (or screws). See following figure.
Goodman Company, L.P .
Antenna
remote RF thermostat.
Advertisement
Related Manuals for Amana DSA01NM
Summary of Contents for Amana DSA01NM
- Page 1 Prior to actual installation, thoroughly familiarize yourself openings. with this Instruction Manual. Pay special attention to all ANTENNA INSTALLATION FOR DSA01NM KIT safety warnings. Often during installation or repair it is An antenna must be installed on the digital PTAC to allow...
- Page 2 DSA01NM thermostat to the wall plate by aligning the 7. Plug wire harness from antenna into the white connec- top two tabs of the thermostat to the top two slots on tor housing on the control board to the right of the the mounting plate.
- Page 3 3. If the thermostat is functioning properly, mount the RF TRANSMITS THROUGH WALLS. thermostat body on the previously installed wall plate. The wireless device, DSA01NM, must be bound to the PTAC for proper in-room communication. Ensure the PTAC unit is CONFIGURATION powered but in the OFF position.
- Page 4 - Consult the dealer or an experienced radio/TV technician required between the equipment and all persons. for help. 5151 S an Felipe, S uite 500 • Houston, TX 77056 www.amana-ptac.com © Copyright 2015 Goodman Company, L.P . is a registered trademark of Maytag Corporation or its related companies and is used under license to Goodman Company, L.P., Houston, TX, USA.