Honda GXV160 Manual page 5

Flywheel brake type:
3.
Move the flywheel brake lever to the brake release position,
and the gasoline engine switch (connected with the
flywheel brake lever) is on
4. Gently pull the starter handle until there is resistance, then
pull quickly in the direction indicated by the arrow. Gently
replace the starter handle.
Pull direction
Do not allow the starter handle to snap back quickly, it should
be put back gently to avoid damaging the starter.
5. If the gasoline engine is started by moving the control
lever to the choke position, after the gasoline engine is
warmed up, the control lever should be gradually moved
to the maximum or
minimum position.
Contro
ller
Choke lever type:
If the choke lever is moved to the OFF position to start the
gasoline engine, it should be gradually moved to the ON
position after the engine has warmed up.
choke lever
The control lever as shown in the picture is connected with
remote control on the equipment equipped with this gasoline
engine. For details, please refer to the instruction manual
provided by the equipment manufacturer.
制动接合
制动松
开
飞轮制动杆
fff
starter handle
min max
choke door
open
6. Flywheel brake type: Keep the flywheel brake lever in
the brake release position. If the flywheel brake lever is
moved to the brake engaged position, the gasoline engine
will stop.
Set gasoline engine speed
Put the control lever to the desired RPM position of the gasoline
engine.
Controller
The control lever as shown in the picture is connected with
remote control on the equipment equipped with this gasoline
engine. For the remote control information and recommended
speed of the gasoline engine, please refer to the instruction
manual provided by
min max
the equipment manufacturer.
5