Table of Contents
Advertisement
2. Origin Sensor Slit Adjustment
2 ．1
Press the key to select the X-Y origin sensor.
2 ．2
❷
❶
X-origin sensor
❸
2 ．3 Adjust the X sensor slit❶ and Y sensor slit ❹ by loosening the screws ❷ ❺ with the central
hole of the button gauge and the needle tip aligned. While adjusting the sensor slit, look at the display of
the panel and tighten screws ❷ ❺ when the display value is "1" to "0" (please note that when
tightening, the sensor slit does not interfere with the sensor ❸ ❻).
2 ．4 Press the key to check that the center hole of the button gauge is combined
with the tip of the needle when the display value of the panel is from 1 to 0 (check each X-Y origin
sensor). If not combined．readjust by 2 .1 - 2 . 4
※After adjustment, attach the right and left bedcovers.
motors by 0.1 mm in a +-direction.
X Displays the selection status of the motor (X origin sensor) or
Y motor (Y origin sensor).
Press the key to switch.
X Expanded reduction rate LED lights: X-point-of-origin sensor
Y Expanded reduction rate LED lights: Y Origin sensor
motor (X origin sensor) and Y motor (Y origin
sensor).
While pressing the key, check the coincidence between the central hole of the
button gauge and the needle tip.
The X/Y origin sensor status selected indicates
"0" or "1".
Keys to drive the selected X/Y
The key switches between the selected X
❹
❺
Y-origin sensor
❻
10Page
Advertisement
Table of Contents
