Table of Contents
Advertisement
CONNECTORS AND PIN OUTS
The CRC-1000 has four connectors on the front that we use.
They are labeled as:
•
J1 – OBDII cable
•
J2 – Power/Ground/Input harness
•
J3 – Handle/Switch harness
•
J4 – Pedal harness
The small connector in the back is not used, but there is a small cutaway for an LED, that can used to observe
operation and limited diagnostics, (see page [12]).
Overall plug colors with the different handle harnesses
Colors of the 394207 may not match exactly as shown below.
[3]
MAN #650541:A
Advertisement
Table of Contents
