Download Print this page
Dakota Digital CRC-1000 Quick Start Manual

Dakota Digital CRC-1000 Quick Start Manual

Drive-by-wire cruise control system
Hide thumbs Also See for CRC-1000:

Advertisement

Quick Links

Introduction
You have purchased one of the finest cruise control systems on the market. The cruise control features:
Enhanced Adaptability
Works with GM LS engine/trans drivetrain
Compact design allows for more mounting locations
Manual or automatic transmission capability
Fully plug and play design
Connects directly to OBD port for less wiring
Easier Installation
Compact module
Single unit mounting
No clutch switch needed
Plug and play design
OBD adaptable for less wiring
Kit Contents/Part numbers
Item
Qty
Description
1
1
Cruise control module
2
1
Switch harness
3
1
Pedal interface harness
5
1
OBD DLC Harness
WARNING: DO NOT USE HAND-HELD 2-WAY TRANSCEIVERS INSIDE YOUR VEHICLE WHILE DRIVING.
WHEN TRANSMITTING FROM INSIDE THE CAR, 2-WAY RADIOS THAT OPERATE IN THE 25MHZ-700MHZ
FREQUENCY RANGE WITH MORE THAN 2.0 WATTS OF POWER CAN PRODUCE ELEC-TROMAGNETIC
INTERFERENCE THAT COULD INTERFERE WITH THE OPERATION OF CRUISE AND THROTTLE CONTROLS
RESULTING IN VEHICLE "LIMP-MODE".
USE OF CELLULAR PHONES WILL NOT INTERFERE WITH THESE CONTROLS.
DUE TO SENSITIVE NATURE OF SIGNALS USED FOR THIS PRODUCT, ALL NON-PLUG AND PLAY CONNECTIONS
MUST BE SOLDERED. FAILURE TO COMPLY WITH THIS REQUIREMENT WILL VOID WARRANTY.
CRC-1000
Drive-by-Wire Cruise Control System
Enhanced Features
Part #
CRC-1000
250-XXXX
250-2766
250-2785
- 1 -
Compact design
Removable wiring harness with locking device
Cruise engaged output (ground signal when
engaged)
Improved Operation
Closer, more accurate control of set speed
Accurate coast/reduce speed
Tap-Up, 1 MPH per tap
Tap-Down, 1 MPH per tap
Controlled resume rate
Recommended Tools
Safety glasses
Volt-Ohm meter
Soldering iron
Electrical tape or heat shrink
Manual #650541

Advertisement

loading

Summary of Contents for Dakota Digital CRC-1000

  • Page 1 CRC-1000 Drive-by-Wire Cruise Control System Introduction You have purchased one of the finest cruise control systems on the market. The cruise control features: Enhanced Adaptability Enhanced Features • Works with GM LS engine/trans drivetrain • Compact design • Compact design allows for more mounting locations •...
  • Page 2 Remove negative battery cable before starting installation process Connect Data harness cap into OBD2 Connect to the accelerator pedal wire: Solder to an ignition wire that is +12V only when key on Black wire: Solder to a chassis ground. *Optional *Cut the OBD connector off and solder wires: Red Wire to Pin 6, Black Wire to Pin 14 - 2 -...
  • Page 3 Brake & Indicator connections Orange-Cruise Indicator (-) Blue-Brake (+) White/Brown-Brake (-) HND (1 and 3) wiring HND 1 & 3 394207 Interface harness HND 2 wiring HND-2 394206 interface harness - 3 - Manual #650541...
  • Page 4 Manual transmission vehicles: It is recommended that you connect this kit to a clutch disengagement switch. You may use an OEM switch or the Dakota Digital (SEN-4206). This cruise kit has two dedicated clutch switch inputs: positive triggered and negative triggered. Use a multi-meter to measure the output of your clutch switch and hook the appropriate wire to the clutch switch.
  • Page 5 Control Box Pin-out Troubleshooting guide: Pin Color Desired Results Fault Condition No power, voltage drop, or intermittent connection will cause +12V when switched on and +0V when switched off. Ignition loss of pedal or ‘Limp-Mode’ condition. must be greater than +10V while cranking vehicle. Lowest resistance to ground and closest to zero (0) ohms as Black A bad ground connection: Cruise will not function, loss of...
  • Page 6 For this reason, the product must not be modified or tampered with! WARRANTY The manufacturer warrants to the original retail purchaser of the Dakota Digital Cruise Control that should this product or any part thereof, under normal use and conditions, be proven defective material or workmanship within 36 months or 36,000 miles of the original purchase, such defect(s) will be repaired or replaced (at the manufacturer’s...
  • Page 7 MPH of your set speed, then press and release the RESUME/ACCEL button. About Dakota Digital Cruise Control The performance of the Cruise Control is dependent upon the condition of the engine, its size and even by the type of emission control equipment it has.