Engineers); Mounting Precautions (For Sharp Dealers And Service Engineers) - Sharp PN-HE751 Operation Manual

Mounting Precautions (For SHARP dealers and service engineers)

When installing, removing or moving the monitor, ensure that this is carried out by at least 4 people. (PN-HE651/PN-HC651 at
least 2 people.)
Be sure to use a wall-mount bracket designed or designated for mounting the monitor.
To attach a VESA-compliant mounting bracket, use M8 screws that are 3/8 inch (10 mm) to 1/2 inch (12 mm) longer than the
thickness of the mounting bracket.
This monitor and bracket must be installed on a wall which can endure at least 4 times or more the weight of the monitor.
Install by the most suitable method for the material and the structure.
Do not use an impact driver.
When moving the monitor, be sure to hold it around the periphery. Do not grasp the screen. This may cause product damage,
failure, or injury.
If you need to temporarily place the monitor on a table or other surface during installation, spread a thick soft cloth on the table
to prevent damage to the screen and table.
After mounting, please carefully ensure the monitor is secure, and not able to come loose from the wall or mount.
Do not use any screw holes other than those for mounting brackets, located on the rear of the monitor, for installation.
The product warranty does not cover damage caused by improper installation, re-modeling, or natural disasters.
Failure to comply with these recommendations could result in voiding the warranty.
Pay attention not to obstruct the air vents with the mounting brackets.
Mounting bracket
• When using commercially-available mounting brackets, make sure that they comply
with the VESA Flat Display Mounting Interface Standard (FDMI).
• Prior to mounting, inspect the installation location to ensure that it is strong enough
to guaranty safety.
• Pay attention not to obstruct part of the air vents of the monitor with the brackets.
• For detailed information, refer to the instructions included with the mounting
equipment.
• There are 4 installation holes on the back. Mount the monitor evenly at the four locations.
(See [Mounting on Walls or Ceilings] for installation.)
• Use screws of the sizes mentioned below to fix the brackets to the monitor. Tighten the screws securely.
(A)
PN-HE751
PN-HE651
PN-HC861 M8
PN-HC751
PN-HC651
Screw Size
(B)
3/8-1/2 inch
+Mounting bracket
(10-12 mm)
11
3/8 - 1/2 inch (10-12 mm)
Screws (M8)
Mounting bracket
Monitor mounting