Table of Contents
Advertisement
Mounting (for Customer)
Contact your supplier as they may be able to provide a list of qualified installation professionals. Mounting the product on a wall
or ceiling and hiring a technician are the customer's responsibility.
Maintenance
• Periodically check for loose screws, gaps, distortions, or other problems that may occur with the mounting equipment. If a
problem is detected, refer to the qualified personnel or the supplier for service.
• Depending on the environment, the mounting location may weaken due to natural degradation. Regularly ask the qualified
personnel to inspect the mounting location and carry out maintenance.
Our company assumes no responsibility regarding any damage that may be caused by inadequate installation, misuse,
modification of the product, natural disasters, or other such causes.
When asking the qualified personnel for installation, inform them of the precautions mentioned in "Mounting Precautions (For
SHARP dealers and service engineers)".
For long-term use
The backlight used for this monitor has a limited life and its brightness decreases with the usage time.
Also, if the same still image is shown for a long time, "Image Persistence" may occur. "Image Persistence" is a phenomenon
in which the image of an LCD remains visible after the image has been changed.
The "Image Persistence" is gradually eliminated by changing the screen, but if the same screen is shown for too long, the
"Image Persistence" will not disappear.
To avoid shortening the monitor's lifetime, consider the following:
• Turn off the main power of the monitor when not in use.
• Use the
button on the main unit or the POWER button on the remote control to put the monitor in standby mode.
• In the OSD menu, go to [Setup] -> [Power save settings] -> [Energy Mode] -> and select [Home] or [Office]. When there is
no input signal, the monitor will automatically switch to power save mode.
• If you cover the panel surface of the main unit with a protective cover made of glass or acrylic, the panel surface will be
sealed and the internal temperature will rise.
Use the computer's power management function or reduce the monitor's brightness to prevent the internal temperature
from rising.
• Use [Schedule] in the OSD menu to automatically turn the monitor on or in Standby state as required.
NOTE:
When using the schedule function, be sure to set [Current Time settings] in the [Schedule] OSD menu.
10
Advertisement
Table of Contents
