Quark-Elec QK-AS07-0183 Quick Start Manual

QK-AS07-0183
The AS07-0183 is designed to be
used out of the box.
Alternatively, AS07-0183 can be Connected via USB adaptor
(optional) to a Windows PC for:
1. Accessing GPS data on a PC via the USB port.
2. Use of the configuration tool for:
a. Filtering of NMEA 0183 output sentences, to eliminate unwanted data
b. Adjusting the baud rate
c. Adjusting output frequency (data transferred once per second). The frequency of
data transfer can be set to 1/2/5/10 per second. 1Hz is the default setting and is gener-
ally recommended. Please note: changing the setting to 10Hz may cause data overflow
in some devices.
These wires need to be connected to the USB adaptor and Power for successful USB
QK-AS07-0183 wire
NMEA0183 Green: TX (NMEA OUT)
Yellow: RX (NMEA IN)
Black (thick): GND shield
POWER Black (thin): GND
Red: Power
TAKE CARE: There are two GND connections.
One is GND for the NMEA Connection, and one is GND for Power. Ensure you
check the above table and your device's documentation carefully before connec-
tion. The device still requires power during USB connection.
BEFORE LEAVING HOME:
We recommend pre-installing any needed Configuration software or
drivers if needed, as you might not have a CD reader/internet access
on site. Driver and configuration software are for use with the RS232
to USB adaptor, they are only needed for the above USB features.
Configuration software (Windows) required.
Hardware driver may be driver. Driver required for Windows. If using
Windows 10, the driver should install automatically, if not, it is in-
cluded on the Free CD and at Quark-elec.com. Driver not required for
Mac.
Configuration software and specific instructions are on the free CD
and at Quark-elec.com
Disclaimer: This product is designed to aid navigation and should be used to augment normal navigational
procedures and practices. It is the user's responsibility to use this product prudently. Neither Quark-elec, nor
their distributors or dealers accept responsibility or liability either to the product user or their estate for any
accident, loss, injury or damage whatsoever arising out of the use or of liability to use this product.
Email: info@quark-elec.com
V1.1(1120)
Connection needed on RS422
device
USB adaptor—RX
USB adaptor—TX
USB adaptor—GND
GND (for Power)
12v—14.4v Power
QK-AS07-0183
NMEA 0183 GPS SENSOR
GPS, GLONASS AND GALILEO
SET-UP GUIDE
Please recycle your packaging
CE, RoHS certified
www.quark-elec.com