Advertisement
ET1111 series (short version)
Industrial Grade Microtype 10/100Base-TX to 100Base-FX Ethernet Media Converter
Assembly, Startup, and Dismantling
Installation
• Installation: Mount the Micro-type unit onto a fixture, or camera housings, e.g. a plank, (either on the wall or on
a flat surface) with at least 2 screws piercing through the holes on the mounting frame to secure it in position.
• Startup: Connect the supply voltage to start up the Media Converter via the terminal block.
• Dismantling: Locate and remove the securing screws. Usually, but not limited to, at least 2 screws.
Manual Earth Green manual is available on our website
www.ot-systems.com
3
V2.3
Advertisement
