Table of Contents
Advertisement
Connections and controls
A wide variety of external equipment can be connected via the sockets located on the side of the television.
Whilst all the necessary adjustments and controls for the television are made using the remote control, the
buttons on the side of the television may be used for some functions.
RED – Power On
GREEN – Active Standby
Switching on
If the power-on light is unlit press the POWER button on the
front of the television to switch the television on, a RED LED
will appear, then press a number button on the remote
control to see the screen.
To put the television into Standby press
control, a GREEN LED will appear for a few seconds then
turn RED. To view the television press
number buttons. The picture may take a few seconds to
appear.
Using the remote control
After first installation, press the MENU button on the remote
control to see the menus.
In digital mode the menu bar at the top of the screens will
show three different topics shown in symbols. As each
symbol is selected by pressing the S or R button on the
remote control, its respective options will appear below.
In analogue mode the menu appears as a list of five
topics. Press the P and Q button to select an topic then
R to see its options.
To use the options press the P and Q button on the
remote control to move up and down through them and
OK, S or R to select the required choice. Follow the on
screen instructions. The functions of each menu are
described in detail throughout the manual.
i
on the remote
i
again or any of the
7
MENU
Power Button
Using the controls and connections
j
+
To alter the volume press
— .
To alter the programme position press
j
+
Press MENU and
— and
sound and picture options in analogue mode only.
Press MENU to finish.
When connecting mono sound equipment to EXT 3,
connect the audio output of the equipment to the L or R
socket on the television, then press
for left mono or Dual II for right mono.
B
To select the Input, press
until the display shows EXT3
as described on page 25. The television will automatically
sense the type of signal.
Please always refer to the owner's manual of the equipment
to be connected for full details.
Please note: Inserting the headphone jack will mute the
sound from all speakers.
INPUT 3
(EXT 3)
.
to control the
O
I/II
to select Dual I
Advertisement
Table of Contents
