Cisco MeetingPlace Video Integration Administrator's Manual page 38

Before You Install
Click Insert.
Step 5
Creating an H.225 Trunk for the Cisco IPVC MCU
From the Cisco CallManager Administration menu bar, choose Device > Trunk.
Step 1
Step 2 Click Add a New Trunk.
For Trunk Type, choose H.225 (Gatekeeper Controlled).
Step 3
Click Next.
Step 4
Enter options:
Step 5
Field
Device Name
Description
Retry Video Call as Audio
Wait for Far End H.245 Terminal Capability Set Check the check box.
Gatekeeper Name
Terminal Type
Technology Prefix
Other parameters
Click Insert.
Step 6
Click OK.
Step 7
Click Reset Trunk.
Step 8
Adding the Route Pattern to Route Calls to the Cisco IPVC MCU
From the Cisco CallManager Administration menu bar, do one of the following:
Step 1
•
•
Click Add a New Route Pattern/Hunt Pilot.
Step 2
Enter options:
Step 3
Administrator's Guide for Cisco MeetingPlace Video Integration Release 5.3
3-16
In Cisco CallManager 4.0, choose Route Plan > Route Pattern/Hunt Pilot.
In Cisco CallManager 4.1, choose Route Plan > Route /Hunt > Route Pattern.
Chapter 3 Installing Cisco MeetingPlace Video Integration
Value
The IP address of your Cisco IPVC MCU.
A name that identifies this trunk.
Check the check box.
The IP address of the gatekeeper to which your
Cisco IPVC MCU is registered.
Gateway
The prefix or pattern that will route calls to
Cisco CallManager.
Values as appropriate for your environment.
OL-6280-01