Cisco MeetingPlace Video Integration Administrator's Manual page 27

Chapter 3 Installing Cisco MeetingPlace Video Integration
Step 1 Click MCU, then click Settings.
Click the Advanced button.
Step 2
Click the Commands button.
Step 3
The Advanced Command dialog box appears.
In the Advanced Command dialog box, do the following:
Step 4
a.
b.
Tip
c.
Creating a Service for Cisco MeetingPlace
You must create a Cisco IPVC MCU service for Cisco MeetingPlace. Before you create a service in the
Cisco IPVC MCU make sure that the media processor (MP) that the Cisco IPVC MCU uses supports
Cisco MeetingPlace.
Table 3-1
Table 3-1
Cisco IPVC Media Processor
Local Cisco IPVC MCU media
processor
Cisco IPVC EMP
Cisco IPVC Rate Matching module
Data Conferencing Card
You can use one of the preconfigured Cisco MeetingPlace service templates or manually create a
Cisco MeetingPlace service.
Using Preconfigured Service Templates
Cisco IPVC MCU, Release 3.5.24 includes three preconfigured services that are designed for Cisco
MeetingPlace.
OL-6280-01
In the Available commands window, click Audio indication interval.
Your selection appears in the Command field.
In the Parameter field, enter the value in milliseconds that you want Cisco MeetingPlace to
announce to video participants that they are in the waiting room and that the conference has not
formally started.
We recommend entering 1500 to establish an interval of 15 seconds.
Click Send, then click Close.
provides information about which Cisco IPVC media processors support Cisco MeetingPlace.
Media Processors That Support Video in Cisco MeetingPlace, Release 5.3
Software Supporting
Cisco MeetingPlace
Release 3.5.24 or later releases
Release 2.0.11 or later releases
Does not support Cisco MeetingPlace
Does not support Cisco MeetingPlace.
Administrator's Guide for Cisco MeetingPlace Video Integration Release 5.3
Before You Install
3-5