Sharp PN-V601 Installation Manuallines page 4

Procedures of Installation
(Please thoroughly observe these recommendations)
We recommend that the following procedures are entrusted to Sharp sales
subsidiaries or dealers/contractors trained by Sharp.
1. Check worker's clothes and their belongings. Wear simple clothes and do NOT put their
mobile phone and/or pen in a pocket.
2. Make enough space before starting the job. Check power cable and/or floor for levelness.
3. The person responsible for the installation directly explains to the workers how to handle the
display securely and shows them examples. Then, start the job.
How-tos for PN-V601 installation
 How to open the box for display.
 How to take the display from the box.
 How to hold the display and the holding position(s) for worker [Attachment precaution 2]
 How to temporarily store the display after taking it from the box.
We recommend temporarily storing the display on a temporary stand.
the surface of LCD monitor on the ground when there is no temporary stand, check whether there
is dust and/or projection, and place on a clean board larger than the display.
-Do not set the PN-V601 on a setting
board smaller than itself to avoid the
contact with corner of the board.
- Use a protecting sheet like blanket
 How to check and/or store the accessories of display.
4. Installation with Wall-mounting Bracket and Stand
- Unlike Sharp "PN-E" standard models, the PN-V601 requires close attention for handling due to its thin bezel.
- Even the dealers or worker familiar with the conventional models must confirm precautions beforehand.
Please study the installation of the Sharp recommended stand as much as possible, and please entrust the
installation work to Sharp sales subsidiaries or dealers /contractors trained by Sharp.
CONFIDENTIAL
- Do not add force from the above.
- Do not drag only the PN-V601
3
If you inevitably put
PN-V601
protecting sheet
like blanket
Setting board larger
than PN-V601
Please set the PN-V601 in the centre
of the setting board/protecting sheet
and be careful to avoid the contact
with corner of the board.
PN-V601 Installation Guidelines <Rev1.4 > September.30, 2010
CONFIDENTIAL