Pentax EPK-i Owner's Manual page 49

Error Messages
If there is a problem that cannot be resolved with any of the above solutions, contact our service personnel.
Message
Please be prepared to replace
the lamp soon.
Please replace the lamp.
Scope is not connected.
Check SCOPE Connection.
W/B Failed!
Please Retry.
Check DV Tape
Check DV Connection
Capture Failed
Check USB Memory
Check Video Printer
PUSH LAMP SWITCH!
AUX LAMP is ON.
No Response from VCU
No VCU Connection
Meaning
Almost time to replace the lamp cartridge. Prepare to replace the lamp.
It is time to replace the lamp cartridge.
The scope is not connected.
Communication with the scope failed.
The white balance is incorrect.
Cannot record to DV equipment.
The DV equipment is not connected
properly or not connected.
Failed to capture the scope image.
No USB memory is connected or there is
insufficient space.
No printer is connected.
The auxiliary lamp is lit.
Communication with Endonet is
abnormal.
No Endonet is connected.
Solution
Press J on the operation panel to
turn on the lamp.
Connect the scope.
Connect the scope.
Set the white balance again.
Check or replace the tape of the DV
equipment.
Connect the DV equipment to the
processor properly.
Try capturing the scope image again.
Connect USB memory that has
sufficient space to the processor.
Connect a printer to the processor.
Press J on the operation panel to
turn on the lamp.
Connect Endonet properly.
Connect Endonet properly.
Troubleshooting
Reference
Page
P.45
P.23
P.15
P.15
P.23
––
––
––
––
––
P.23
––
––
6
49