Replacing The Fuses; Repair - Pentax EPK-i Owner's Manual

Replacing the Fuses

If the processor does not work even if you press R to turn on the processor, check whether the fuses have blown.
1
Press R to turn off the processor and disconnect the power cord.
2
Insert a screwdriver on the left/right side of the fuse
box and use it to pull out the fuse box. (Refer to
Figure 5.5.)
3
Position the fuse box so that its back is facing you
and remove the fuses. (Refer to Figure 5.6.)
4
Check both fuses.
•• If even one fuse has blown, both fuses must be replaced.
NOTE
When replacing the fuses, be sure to use only specified fuses
( 5 × 20, 6.3 A).
If both fuses have not blown, contact our service personnel.
5
Reinsert the fuse box.
6
Connect the power cord, press R to turn on the processor, and make sure the R LED lights.
NOTE
If the processor cannot be turned on even after the fuses have been replaced with new ones, immediately turn off the
power, disconnect the power cord, and contact our service personnel.

Repair

Before submitting the processor for repair, be sure to follow the instructions in
“"Maintenance and Storage”" (P.43) in order to prevent infections.
Observe the following points when sending the processor for repair.
•• Use appropriate packing to prevent the processor from being broken or damaged during transport.
•• Make sure you write down and include details of the malfunction, the processor manufacturing number, your name and
contact details, and the destination address.
•• Send all accessories that you think may be in any way related to the malfunction together with the processor.
NOTE
PENTAX is responsible for any repairs it undertakes. Note, however, that PENTAX is in no way liable for any injuries to
patients or users, damage or malfunction of the processor, and disinfection or sterilization problems resulting from
repairs being undertaken by any party other than PENTAX.
Figure 5.5
Figure 5.6
Maintenance and Storage
5
47