English - Kärcher T 80 T-Racer Original Instructions Manual

Safety instructions
Please read and comply with
these original instructions prior
to the initial operation of your appliance and
store them for later use or subsequent own-
ers.
 Please observe the safety instructions
of your high-pressure cleaner.
 Only trigger the high-pressure jet at the
high-pressure gun if the T-Racer is lo-
cated on the surface to be cleaned.
 There must be no persons in the imme-
diate vicinity of the cleaning head.
 Beware of the recoil force! Ensure a
stable position and firmly hold the high-
pressure gun with the extension tube or
the handle.
 Switch off the high-pressure cleaner
when you finish cleaning. If you are us-
ing the T-Racer then disconnect the
same from the high-pressure gun.
 Maximum water temperature 60°C
(please observe the instructions of your
high-pressure cleaner).
Symbols on the machine
Danger!
Do not hold under the edge of the
T-Racer when it is on!

6 English

Description of the Appliance
When unpacking the product, make sure
that no accessories are missing and that
none of the package contents have been
damaged. If you detect any transport dam-
ages please contact your dealer.
 See page 2, illustration
1 Casing
2 Bayonet connection with safety cover
3 Extension tube
4 High pressure nozzle
5 Rotor arm
Proper use
The T-Racer is ideally suited for the clean-
ing of floor and wall surfaces made of differ-
ent materials, such as wood, plastic,
concrete, tiles, and natural stone. Use the
T-Racer exclusively in your private house-
hold.
Application
Note: Always use Kärcher water filter (or-
der no. 4.730-059.0) during suction opera-
tions of the high-pressure cleaner.
Cleaning floor surfaces
Fasten the T-Racer to the high-pressure
gun using the extension pipe.
 Illustration
1 Press the extension tube into the bayo-
net connection of the high-pressure
gun, then turn by 90° until it locks into
place.
2 Tighten the safety cover.
Repeat this process even for the other con-
nections.
Tips for cleaning
 The T-Racer is not suited for scouring
or scrubbing!
 Outdoor surfaces should be swept be-
fore the T-Racer is used to avoid dam-
aging the high-pressure nozzles.
Caution
 Illustration
Do not run over protruding corners!