Hobot -298 User Manual page 19

Step 3.
Make sure the battery is fully charged (green light ON) before using:
(1) Plug it into a power source. Orange light ON means charging.
(2) Green light ON means the battery is fully charged.
(3) Charge the battery for at least 6 hours when using the robot after a long
period of inactive time.
Step 4.
Make sure to put the cleaning cloth onto the device correctly to avoid air
leakage.
(1) HOBOT has 2-laser sensors for detecting glass edge. These laser
sensors cannot be covered by cleaning cloth like as shown.
(2) Put cleaning cloth onto device flatly and do not let cloth cover the
caterpillar wheel and laser sensors.
Caterpillar wheel
Step 5.
Fill the water tank with water or HOBOT window detergent and tighten the
tank lid fully after filling.
Step 6.
Put the device onto window.
(5) Turn power switch on make sure fan is running.
(6) Put device onto window and keep 10cm away from the window frame.
(7) Check if device is sticking to the window before releasing it.
Step 7.
Auto mode or manual mode operation.
(1) Operate HOBOT by remote control. There are 3 kinds auto mode (
(2) Press
(3) Press
Step 8.
Finish and remove the device from window.
(1) While device is running, hold the safety rope with one hand and take
device down from window with the other hand.
2-laser sensor
) that could automatically clean whole window.
or to stop device running.
to manually control device moving.
X
- 18 - SmartBot HOBOT – www.hobot.es
O