Table of Contents Copyright ................i Trademarks ............... i Disclaimer ................. i Safety information ............. i Technical support .............. i Product introduction ............1 Products and accessories ..........1 Product features ............... 1 Getting to know the device ..........2 Main terminal ................
Product introduction First of all, thank you for choosing WINBOT 68, the revolutionary window auto- cleaning robot with Artificial Intelligence technology! Please read this user manual carefully before the usage of WINBOT. It has two terminals: the main terminal and the sub terminal.
Getting to know the device Main terminal 1. Hanging hole 2. Blue LED indicator #3 3. Blue LED indicator #6 4. Blue LED indicator #2 5. Blue LED indicator #1 6. Green LED indicator 7. Red LED indicator 8. Blue LED indicator #4 9.
Indicators Meaning The blue indicator that is close to Blockage is detected. the blockage flashes. The blue indicators no. 1, 3, 4, and 6 5mm glass is detected. flash 3 times. The green indicator is on. Self-test is failed. The temperature of the motor is too The green indicator flashes.
Modes and directions Button on remote controller Mode Auto up then down Auto left then down Auto right then down Direction Using your device Please handle with care to avoid any chance of hand-caught. 1. Select the appropriate cleaning rings for the main and the sub terminals. Refer to "Using the cleaning ring and the cleaning cloth"...
4. Connect the DC extension cable with the power adapter then plug the L- shape connector into the main terminal. Power adapter DC plug L-shape connector DC extension cable 5. Connect the power adapter with the power cord. 6. Plug into the power. 7.
3. Put cleaning ring on wheels of the main and the sub terminals. The purpose of using different cleaning ring is to ensure Glass thickness + cleaning ring thickness = 10mm. Choosing the appropriate cleaning ring Always make sure the thickness of the glass and the cleaning ring is 10mm in total.
WINBOT’s working area Defining working area Use silver reflective tape to define WINBOT’s working area and use black silver tape for reflective glass. reflective tape The silver reflective tape on the indoor Outdoor window should be aligned with the outer window frame Indoor...
Ways to clean window Method Circumstances Procedures 1. Use a clean cleaning cloth to polish. For window with small 2. You may spray some water or cleaning Dry clean amount of sand/dust. product on to the window when cleaning. If it's rainy or humid outside 1.
Frequently asked questions (FAQ) Question Possible solution • Please check the section "Using the cleaning I don’t know my glass thickness. ring and the cleaning cloth" on page 5. • Try to start with 5mm ring. In the self-test WINBOT does at the Use a thicker cleaning ring (bigger number beginning, 3 LEDs on the top of WINBOT ring).
Page 13
Question Possible solution If the cleaning wheels on the main and the sub terminals have not detached, you can do one of the following: 1. Switch the power off and on. 2. Move WINBOT to a safe location using the remote controller.
Page 14
Question Possible solution • If the window is partially opened, the sub terminal will run into another window. Make sure all windows are closed. • If the outdoor window frame is smaller than What if WINBOT touches the window frame the indoor one, WINBOT might hit or stuck and makes alert or even stops with “running into the window frame.
• Do not use the adapter if it becomes damaged. • Do not attempt to service the adapter. There are no service parts inside. Replace the unit if it is damaged or exposed to excess moisture. Consult your HOBOT dealer for help and maintenance.