Advertisement
Figure 11
Removing the CompactFlash from the Adapter
1
To install the CompactFlash in the adapter, follow these steps:
Step 1
Remove the replacement CompactFlash from its packaging.
Grasp the empty adapter and the CompactFlash, and position the CompactFlash in front of the adapter
Step 2
as shown in
Step 3
Slide the CompactFlash into the adapter until the CompactFlash is firmly seated in the adapter connector.
(See
Note
Install the CompactFlash adapter in the DIMM socket using
Step 4
Reinstall the Supervisor Engine 720 in the chassis following the
Step 5
720" procedure on page
78-17277-05
Figure
12, View 1. Align the slots in the CompactFlash with the rails in the adapter.
Figure
12, Views 2 and 3.)
To make good electrical contact, you must fully insert the adapter's connector pins into the
CompactFlash; the pins should not be visible.
16.
Removing and Installing the CompactFlash in the CompactFlash Adapter
2
Cisco CompactFlash Adapter for Bootflash Upgrade Installation Note
3
Step 6
and
Step 7
on Page 15.
"Reinstalling the Supervisor Engine
23
Advertisement
