Advertisement
Figure 3
Installing the CompactFlash Adapter
To install the CompactFlash adapter, follow these steps:
Locate the SP BOOTFLASH DIMM socket on the Supervisor Engine 720. (See
Step 1
BOOTFLASH DIMM is on the left side of the Supervisor Engine 720 as you face the front of the board;
the RP BOOTFLASH DIMM is on the right side of the Supervisor Engine 720 as you face the front of
the board.
Note
78-17277-05
Removing the Module from the Chassis (Horizontal Chassis Shown)
1
2
WS-X6624-FXS
3
24 PORT FXS ANALOG
STATION
WS-X6624-FXS
4
24 PORT FXS ANALOG
STATION
5
WS-X6348-RJ-45 V
6
o
The DIMM is a sensitive component that is susceptible to ESD damage. To prevent ESD damage,
wear an ESD grounding wrist strap and handle the DIMM by the edges only; avoid touching the
memory modules, pins, or traces (including the metal fingers along the connector edge of the
DIMM). Attach an ESD grounding strap to your wrist and to ground. (If you are unsure about
the correct way to attach an ESD grounding strap, see the
Strap" section on page 24
48 PORT
10/100 BASE-T
ETHERNET SWITCHING
MODULE
o
INPUT
FAN
OUTPU T
OK
OK
FAIL
for instructions.)
Cisco CompactFlash Adapter for Bootflash Upgrade Installation Note
Installing the SP Bootflash Memory Upgrade Kit
INPUT
FAN
OUTPU T
OK
OK
FAIL
Figure
4.) The SP
"Attaching Your ESD Grounding
13
Advertisement
