Philips Salon Multistylist HP4698 Manual page 14

Hide thumbs Also See for Salon Multistylist HP4698:
Table of Contents

Advertisement

EnglisH
1
Problem
The styling
results are not
satisfactory.
Solution
Perhaps the appliance is not suitable for the mains
voltage to which it is connected. Make sure that the
voltage indicated on the appliance corresponds to
the local mains voltage.
Perhaps the mains cord of the appliance is damaged.
If the mains cord is damaged, you must have it
replaced by Philips, a service centre authorised by
Philips or similarly qualified persons in order to avoid
a hazard.
Perhaps you did not let the appliance heat up long
enough. Let the appliance heat up until the ready
dot changes colour.
Perhaps you wound too much hair round the barrel
or put too much hair between the plates. When you
use the curling attachments or the slide-on brush, do
not make the locks too thick. The thinner the lock of
hair, the tighter the curl. When you use
the straightening attachment, make sure the locks are
no wider than 5 to 6cm for a good result.
Perhaps you did not leave the styling attachment in
your hair long enough. Keep the styler in your hair
for 5 to 10 seconds, depending on the thickness of
your hair.

Advertisement

Table of Contents
loading

Table of Contents