Table of Contents
Advertisement
Parts and Functions
17.SLEEP Button
(The clock must be corrected before setting sleep function)
Used to set sleep mode.
18.FAN Button
Used to select fan speed:LOW,MID,HIGH,AUTO.
19.TIMER OFF Display
20.TIMER Display
21.FILTER Display
When the filter need be cleaned, the sign will
appear automatically.
22.TEMPERATURE Display
23.AUTO SWING Display
24.HIGN/SO Run Display
25.Code A display
Code A is used for this unit
26.SIGNAL SENDING Display
27.Code B display
28.Fresh Display
29.Auxiliary ELECTRICAL HEATING Display
30.HEALTH Display
Displays when healthy run function is set.
31.Operation MODE Display
AUTO RUN COOL RUN DRY RUN HEAT RUN FAN RUN
32.SLEEP State Display
33.BATTERY Energy Display
Notify the user when it is time to change
the batteries.
34.LOCK State Display
35.FAN SPEED Display
LOW
MID
36.TIMER ON Display
37.HEAT Button
Used to select auxiliary heater.
Remote Controller Operation
When in use, direct signal transmission
head to the receiver placed on the
indoor unit
Clock Set
When unit is started for the first time and after replacing batteries in remote
controller, clock should be adjusted as follows:
1.Press CLOCK button, clock indication of " AM " or " PM " flashes.
2.Press
or
to set correct time. Each press will increase or decrease
1 min. If the button is kept pressed, time will increase or decrease quickly.
3.After time setting is confirmed, press "SET" : AM or PM stop flashing,
while clock starts working.
Note:AM means morning and PM means afternoon.
HIGH
8
The distance between the remote controller and the receiver
should be max 7m and there should be no obstacle between
them.
Do not throw the remote controller; prevent it from being
damaged.
When operating the remote controller in an area where
electronically controlled lights are installed or wireless
handsets are used, please move closer to the indoor unit
as the function of the remote controller might be affected
by signals emitted by the above mentioned equipments.
Battery loading
Battery loading
Batteries are fitted as follows:
Remove the battery compartment lid
Slightly press and disengage the battery compartment lid
marked with ì î and then hold the remote controller by the
upper section and then remove the battery compartment
lid by pressing in the direction of the arrow as shown in the
figure above.
Loading the battery
Ensure that batteries are correctly placed in the compartment as
required for positive and negative terminals.
Replacing the battery compartment lid
The battery compartment lid is reinstalled in the reverse sequence.
Display review
Press the button to see if batteries are properly fitted. If no display
appears, refit the batteries.
Confirmation indicator
If no indication is displayed after press ON/OFF button,
reload the batteries.
Caution:
If the remote controller does not operate as designed after
fitting new batteries of the same
type, press the Reset button (marked ) with a pointed
article.
Note:
It is recommended that the batteries be removed from the
compartment if the remote controller is not used for an
extended period.
The remote controller is programmed for automatic test of
operation mode after the batteries are replaced. When the
test is conducted, all icons will appear on the screen and
then disappear if the batteries are properly fitted.
When throw away the waste batteries, please perform in
accordance with the local regulation.
MODE
SLEEP
HEALTH
FRESH
CLOCK
SET
3
1
TIMER
2
HIGH/SO
FILTER
HEAT
LIGHT
LOCK
RESET
CODE
Advertisement
Table of Contents
