Philips FC7088 Important Information Manual page 12

ENGLISH
12
Problem
Water drips out
of the appliance.
I cannot remove
the mopping
brushes.
I cannot tilt the
appliance
backwards
without the
nozzle coming off
the floor.
The appliance
does not take up
water when I
flush the
mopping nozzle
and the red
mopping brushes
light lights up
continuously.
I cannot move
the appliance
forwards or
backwards.
Possible cause
If the blue tank full/tank
empty light continues to
flash after filling, the
clean water tank is not
placed or locked
properly.
Water leaks from the
dirty water tank because
you tilted the upper
body too far backwards
or because you put the
appliance on its side. This
caused wastewater to
flow out of the dirty
water tank.
You probably tried to
remove them by pulling
at the wrong side.
The appliance is locked
in parking position.
You poured too much
water into the flushing
tray or you poured it in
too fast. This causes the
mopping brushes to
become too wet. When
the brushes are too wet,
the active protection
system is activated.
One or more wheels are
blocked by a small
object.
Solution
Make sure that you place the clean water tank
properly and make sure that the lever is locked.
Do not tilt the upper body of the appliance too
far backwards, for instance when you clean under
a low table. Do not put the appliance on its side
when there is wastewater in the dirty water tank
(see chapter 'Important', section 'Caution').
Grab the lime green grips of the brushes and pull
the brushes up a little. Then you should be able to
slide them off the projection on the other side.
Press the nozzle with your foot and release the
appliance from parking position.
Switch off the appliance, put the appliance upright
in parking position ('click'), and pull the plug out of
the wall socket. Remove the mopping brushes
from the mopping nozzle and remove excess
water from the mopping brushes by squeezing
them over a sink. Then you can reinsert the
mopping brushes, reinsert the mopping brush
cover, close the mopping nozzle lid and switch on
the appliance again. If this does not work, let the
mopping brushes dry.
Switch off and unplug the appliance and then put
it on its side. Make sure that the dirty water tank
is empty when you put the appliance on its side,
otherwise wastewater may leak out of the dirty
water tank. Check if an object blocks the wheel(s).
Remove this object. Put the appliance upright
again and resume cleaning.