Name Of Each Part - Haier AB142ACBBA Operation Manual

Name of Each Part

1.ON//OFF button
2.Temperature display
3.Clock display
4.Timer ON/OFF display
5.Humidity display
6.Air filter cleaning display
When there is too much duct
collected on the air inlet, the
wire controller will show this
display to remind the user to
clean the air inlet. After cleaning
and installation, just press the
air filter reset button
7.Super/Soft operation display
8.Fan speed display
AUTO
High Auto
low
Mid
9.Health state display
10.Fresh air state display
Note:
1.Cooling only type air conditioner does not have thedisplay and functions related with heating.
2.This model does not have the following related display and function 5 7 9
Calibration of clock
When turning on the unit for the first time, the clock should be calibrated. The method of
calibration is:
1.Press ìClockî button, the Clock display ìAMî ìPMî will flash.
2.Press or to adjust time. For each press, the time will increase or decrease 1 minute.
If depressing the button, the time will increase or decrease rapidly.
3.After confirming the time, press ìSetî button, ìAMî or ìPMî will stop flashing, the clock
will begin to work.
1 2
1 3 1 4 1 5 1 6
1 1
1 0
9
O T U A
8
7
6
S E T
5 C
R O O M
N O F F O
M A M A
M P M P
4
3
2
1
11.Humidifying state display
12.Sleep state display
13.Network control display
14.Working mode display
AUTO RUN COOL RUN DRY RUN HEAT RUN
15.Electric heating display
16.Operation mode button
Used to set working mode:
Auto,Cooling,Dry,Heating,Fan
17.Fan speed button
Used to set fan speed:
Low Fan, Mid Fan, High Fan, Auto
18.Temperature Setting button
Used to set temperature,
temperature range: 16 C~30 C
19.Clock button
Used to calibrate the time of timer
and clock
20.Setting button
Used to confirm the time
of timer and clock
6
1 7
F A N S W I N G
M O D E
1 8
T E M P
1 9
C L O C K S E T
2 0
T I M E R S L E E P
2 1
2 2
F I L T E R R E S E T
R E S E T
2 3
2 4
ON/OFF
2 5
2 6
21.Sleep button
Used to confirm the time
of timer and clock
22.Time Adjusting button
Used to adjust the time of
FAN RUN
timer and clock
23.Reset button
When the wire controller appears
abnormal condition, use asharp-
pointed article topress this button
to make the wirecontroller resume
normal
24.Air Filter Reset button
After cleaning the air inlet,
press thisbutton, the unit
can start to operate
25.Timer button
Used to set the mode of timer
26.Lock state display
10 11 15
.