Installation Procedures
1. Remove upper part of wire controller
Remove upper part of wire controller by press.
PCB is mounted on lower part of wire controller, be careful not to
damage it.
2. Install wire controller
(1) For exposed installation,
use 2 wood screws (accessory).
(2) For recessed installation,
use 2 wood screws (accessory).
3.The dial code is set as:
1. ON 2.OFF 3.ON 4.OFF
Note:
Try as far as possible a flat surface for installation. Don't use excessi
force when tightening screws, or lower part might got deformed.
Upper part of wire
controller
Lower part of wire
controller
22