Maintenance And Care - Kärcher PC 100 M1 BIO Manual

Maintenance and care

Daily
Check whether the indicator lamp
"Refill detergent solution" illumi-
nates.
If the indicator lamp illuminates,
pour 20 liters of detergent fluid
RM PC-BIO into the basin.
Note
Do not overfill the container. The max-
imum filling level is achieved when the
swimmer of the filling level sensor has
reached its highest possible position.
If in doubt, remove the basin and check
the fill level.
If the indicator lamp "Refill detergent"
illuminates, the heating of the deter-
gent is switched off. The degradation
performance of the microbe will re-
duce.
Clean small parts and shavings
strainer.
Monthly
Remove rinsing floor.
Remove filter mat.
Insert new filter mat.
Hold the old filter mat over the new
filter mat and wring it out.
Please dispose of used filter mats
according to the local regulations
for special waste (see "Instructions
for disposal").
Replace the rinsing floor.
Note
Dispose of used filter mats according
to the local regulations for waste con-
taining mineral oil.
If the filter mat is only slightly dirty, the
changing interval can be stretched to
two months.
Yearly
Danger
Risk of the heating element catching
fire.
Risk of electric shock.
First remove the mains plug before do-
ing any job on the appliance.
PC 100 M2 BIO only - remove wing
nuts.
Raise the basin and tilt it to the side.
Scoop out the particles floating on
the detergent liquid.
Pump the detergent fluid into a suit-
able container.
If the oil floats on the detergent flu-
id, stop pumping when oil starts
coming out of the pump. Scoop out
the oil by hand and dispose of ac-
cording to the local regulations.
Rinse container and pump with wa-
ter.
Check status of hose pipes.
Replace the basin.
PC 100 M1 BIO only
Warning
Risk of damage to the hose pipe in the
container if it comes in contact with the
heating element. Replace the basin so
that the pump in the tank is located on
the same side as the locking valves of
the cleaning tools.
PC 100 M2 BIO only - tighten the
wing nuts.
Remove rinsing floor.
Remove filter mat.
Insert new filter mat.
Hold the old filter mat over the new
filter mat and wring it out.
Please dispose of used filter mats
according to the local regulations
for special waste (see "Instructions
for disposal").
9
English