Ce Declaration; Warranty - Kärcher BC 14/12 Original Instructions Manual

Fault
Motor does not turn.
Motor does not turn, clean-
ing head does not turn
Cleaning head only turns
around one axle or abruptly
Uneven cleaning jet
Spray volume too low.
Significant quantities of
cleaning liquid are leaking
from the drainage borings
of the support pipe.
Significant pressure loss,
but no cleaning liquid leaks
at the drainage borings
Appliance does not vacuum The suction tube has been in-
Although the switching le-
ver is in the SUCTION posi-
tion, water will continue to
flow from the spray nozzles.

CE declaration

We hereby declare that the machine de-
scribed below complies with the relevant
basic safety and health requirements of the
EU Directives, both in its basic design and
construction as well as in the version put
into circulation by us. This declaration shall
cease to be valid if the machine is modified
without our prior approval.
Product: Internal cleaner
Type: BC 14/12
Relevant EU Directives
2004/108/EC
Applied harmonized standards
EN 61000-6-3
EN 61000–3–2: 2006
EN 61000–3–3: 2006
EN 62233: 2008
The undersigned act on behalf and under
the power of attorney of the company man-
agement.
Head of Approbation
CEO
Alfred Kärcher GmbH Co. KG
Alfred-Kärcher-Str. 28 - 40
D - 71364 Winnenden
12
English
Possible cause
There is no voltage at the motor.
Thermal protection switch in the
coil has triggered.
Error current protective switch was
triggered.
Interior cleaner is switched off.
Drive parts in support pipe broken. Check parts and replace defective parts.
Cleaning head touches container
wall.
Excessive tooth play in the bevel
wheels.
Destroyed gears on bevel wheels. Replace bevel wheels.
Spray nozzles clogged.
Spray nozzles damaged.
Leak on the cleaning head or its
supply line.
Filter in the supply line plugged.
Slide ring gaskets in the support
pipe are worn.
Slide ring gaskets in the cleaning
head are worn.
stalled wrongly.
Wear of the suction nozzle.
Openings for the suctioning of the
water are plugged.
Wear of the valve seal.
Phone: +49 7195 14-0
Fax: +49 7195 14-2212
The warranty terms published by our com-
petent sales company are applicable in
each country. We will repair potential fail-
ures of the appliance within the warranty
period free of charge, provided that such
failure is caused by faulty material or de-
fects in fabrication.
In the event of a warranty claim please con-
tact your dealer or the nearest authorized
Customer Service centre. Please submit
the appliance, including all accessories,
and the proof of purchase.
Troubleshooting
Remedy
Check fuse, power supply and cables.
Fix cause for overload.
Remove cause and reset error current protective
switch.
Switch the interior on at the appliance switch.
Change position of cleaning head and make
sure it can run smoothly.
Adjust and replace worn parts.
Clean spray nozzles.
Replace spray nozzles.
Check pump, check pressure lines/hoses.
Clean filter.
Check parts and replace defective parts.
Check parts and replace defective parts.
Properly screw the suction tube onto the match-
ing connection.
Clean suction nozzle.
Clean the openings and water passages.
Replace valve seals.

Warranty

of whom
Electricians
Electricians
Electricians
Operator
Customer Service
Operator
Customer Service
Customer Service
Operator
Operator
Operator
Operator
Customer Service
Operator
Operator
Operator
Operator
Customer Service