Kärcher FC 3 Cordless Operator's Manual page 25

Poor cleaning result
The rollers are dirty.
Clean the rollers.

Rollers are not being sufficiently mois-
tened.
Moisten the rollers by moving back

and forth over the same position.
Incorrect detergent or incorrect dos-
age.
Use only KÄRCHER detergent and

be sure to use the correct dosage.
Foreign detergents are present on the
floor.
Remove all detergent residues from

the rollers using water.
Clean the floor several times using

the device and clean rollers, without
using detergent. This removes de-
tergent residues from the floor
Rollers do not turn
Rollers are blocked.
Remove rollers and check if an ob-

ject has become stuck in the rollers.
Check that the rollers are screwed

in as far as they will go onto the roll-
er holder.
Check that the floor head cover is

correctly seated. For this, remove
the cover and then fit it back in
place.
✓
Water pick up not optimum
Floor head cover not installed correctly
Check that the floor head cover is

correctly seated. For this, remove the
cover and then fit it back in place.
The rollers are worn out.
Replace the rollers.

Appliance is leaking waste water
Waste water tank is overfilled.
Empty the waste water tank right

away.
Waste water tank does not fit properly
in the appliance.
Check that the floor head cover is firm-

ly seated on the waste water tank.
Check that the waste water tank

flaps are correctly closed.
Removing handle from device
ATTENTION
Do not remove handle from the device
once assembled.
The handle may only be removed for
shipping service purposes.
Insert screwdriver at a 90 degree

angle in small opening at rear of de-
vice and simultaneously pull handle
up until it slides off.
30
2.
ATTENTION
Please ensure cord between body and
handle are not damaged.
Pull carefully to avoid damaging the
device.
1.
English 25