Package Contents; Product Overview; Software Installation; Installation & Initial Startup - Mustek PM 600 PLUS User Manual

PM 600 PLUS Line Interactive Schuko

1. Package Contents

You should have received the following items inside of package:
- UPS Unit
- Startup Manual
- Communication cable
- Installation CD for monitoring software

2. Product Overview

Schuko

3. Software Installation

1. Insert the included installation CD into CD-ROM drive and then
follow the on-screen instructions. If there no screen shows when
inserting the CD after 1 minute, please execute setup.exe for
initiating installation software.
2. Enter Serial No label pasted on the UPS unit to install the
software.
3. When your computer restarts, the monitoring software will
appear as a green plug icon located in the system tray, near the
clock

5. Status Indicators

Status
AC Mode
On Battery
Low Battery
Battery Replacement
Overload
UPS Fault
WARNING: This is a UPS Class C2. In residential subdivision the product may cause harmful interference, then the users have to take additional
measures.

Battery backup
receptacles

Status indicators

AC power input

Circuit breaker

Modem/phone/
Network surge
protection

Coaxial surge
protection (option)

USB communication
port

Power switch
Visual Indication
Green Power On LED - On
Yellow Batt. Mode LED - Flash
Yellow Batt. Mode LED - Flash
Red Fault LED - On
Green Power On LED on
Red Fault LED - On
4. Installation & Initial Startup
NOTE: Before installation, please inspect the unit. Be
sure that nothing inside the package is damaged.
Connect to Utility and Charging
Plug in the AC input cord to the wall
outlet. For the best results, suggest to
charge the battery at least 4 hours
before initial use. The unit charges its
battery while connecting to the utility.
Connect the Loads
Plug in the loads to output receptacles on the
rear panel of the UPS. Simply turn on the power
switch of UPS unit, then devices connected to
the UPS will be protected by UPS unit.
CAUTION: NEVER connect a laser printer or
scanner to the UPS unit. This may cause the
damage of the unit.
Connect Modem/Phone/Network to Surge Protection
Connect a single modem/phone/network line into surge-protected
"IN" outlet on the back panel of the UPS unit. Connect from "OUT"
outlet to the computer with phone line cable.
Connect Coax Protected Port
port only)
This coax protected port will protect your TV antenna, cable, and
network.
Turn On/Off the Unit
Turn on the UPS unit by pressing the power switch. Turn off the
UPS unit by pressing again the power switch. You may check the
Status Indicators Section for the details.
Cold Start Function
When the UPS is off and there is no power utility, it's still possible to
cold start the UPS unit to power the loads.
Alarm
Not applicable
Sounding every 10 seconds
Sounding every second
Sounding every 2 seconds
Sounding every 0.5 seconds
Continuously sounding
Startup manual V.1.0
(For the model with coax protected
EN