Dry Pick Up; Components Description - Tennant V-CAN-12 Series Operator's Manual

or spark can cause damages to electronic
components and persons.
Warning: do not tamper or modify the
appliance. Failure to comply with these
instructions
personal injury or death. Tampering will
void the warranty.
The manufacturer refuses all responsibility
for damages or injuries due to improper
use of the machine or in case of failure to
failure to comply with the instructions
given in this manual.
Always disconnect power cord from
power source after operating and before
servicing. After every use and before
sending the appliance to a service center,
it must be thoroughly cleaned and tank rinsed out
to avoid hazard.
-
Do routine maintenance. Inspect gaskets seals,
plastic parts, filters, switches and replace those
which have begun to leak or are damaged.
-
Using a machine with a damaged power cord could
result in an electrocution. Check the cord looking
for cut, cracks or aging signs and replace it, if it's
necessary.
-
Only an authorized service centre can replace power
cord of the appliance.
-
If extension cord are used, ensure that the cable
rating is suitable for use with the equipment. Keep
dry at all times. Avoid contact with conductive
surfaces.
-
Only an authorized service centre can do reparation
or maintenance of the appliance. Use only original
spare parts.
-
To keep the appliance fully functional it is necessary
to clean polyester filter shaking it after every use and
replace filtering bag if it's full.
-
Clean every part of the appliance after each use:
empty the tank, shake the filters, replace filtering
bag if it's full and clean the machine with a damp
cloth before storing the vacuum cleaner.
-
During a power quality disturbance of the facilities
electrical grid, this appliance may cause temporary
drops in voltage.
-
Only V-CAN-16: When the service indicator light
turns on:
the vacuum bag is full → replace it
the main filter is clogged → clean the main filter
the vacuum hose is clogged → unclog it
-
Stop using the vacuum cleaner if the service
indicator light turns on. Overheating can take
place, causing permanent damages to the motor.
DRY PICK UP (PAGE 52)
1. Insert main filter into the tank (Fig. 1).
2. Mount the head on top of tank and lock it with
hooks (Fig. 2).
3. Push hose into hose inlet (Fig. 3).
4. Attach wand and desired tool to hose ends (Fig. 4).
5. If your vacuum is equipped with paper bag, slide
paper bag over the deflector (Fig. 6).
6. Plug power cord into a proper outlet and turn
cleaner on (Fig. 5).
COMPONENTS DESCRIPTION (PAGE 52)
A - Motor head
B - On/Off Switch
C - Latches
D - Inlet
could result in severe
E - Tank
F - Castor wheels
G - Main filter
H1 - Exhaust air foam filter (only V-CAN-12)
H2 - Exhaust air cartridge filter (only V-CAN-16)
I - Vacuum hose
J1 - Two-piece wand(only V-CAN-12)
J2 - Telescopic wand (only V-CAN-16)
K - Hose nozzle
L - Crevice tool
M - Round brush
N - Upholstery tool
O - Adjustable floor tool
P - Vacuum bag. Always use the main filter with
vacuum bag.
Q - Speed regulator knob (only V-CAN-16)
R - Service indicator light (only V-CAN-16)
TENNANT V-CAN-12 / V-CAN-16
EN
3