Installing The Remote Control; Testing The Remote Control; Setting The Remote Control - Philips SRU 5110/87 Manual

2.2

Testing the remote control

The remote control has been programmed to operate the most-used
functions of almost any brand of TV. Because the SRU 5110 may use
different signals for each brand and even for different models of the same
brand, it is advisable to test whether your device responds to the
SRU 5110.The example below instructs you how to do this.
Turn your TV on manually or use the original remote control.
1
Tune to channel 1.
Check whether all the keys are working.
2
For an overview of the keys and their functions see
'3. Keys and functions'.
• If the TV responds as it should to all of the key commands the SRU 5110
is ready for use.
Tip
If the TV does not respond at all or not to all of the key commands, follow
the instructions under '2.3 Setting the remote control', or for online setup go
to: www.philips.com/urc.
2.3

Setting the remote control

This is only necessary if your TV does not respond to the SRU 5110.
If that is the case, the SRU 5110 does not recognize the brand and/or
model of your TV and you need to program the remote control to do so.
Turn on the TV manually or use the original remote control.Tune in
1
to channel 1.
Look up the brand of your TV in the code list at the back of this
2
manual. A four-figure code is shown for each brand.
Note the code for your brand.
4
2
3

Installing the remote control

2
3