Table of Contents
Advertisement
RU530_00.qxd 04-06-2004 16:58 Pagina 4
Instructions for use
2. Installing the remote control
Inserting the batteries
1
Press the cover inwards and slide it in the
direction of the arrow.
2
Place two R03, UM4 or AAA type batteries
into the battery compartment, as shown.
3
Slide the cover back and click it firmly into
place.
Testing the remote control
The remote control has been programmed to operate most Philips
appliances. Because the RU530 may use different signals for each make and
even for different models of the same make, it is advisable to test whether
your appliance responds to the RU530.
The example below (TV) instructs you how to do this.
You can repeat the same steps for other appliances
(VCR, satellite or cable decoder) which you want to operate using the
RU530.
Example of TV:
1
Turn your TV on manually or use the original remote control.
Tune to channel 1.
2
Use the RU530's mode selector to select TV.
Press the key until the green light under TV in
the selector window lights up.
If no green light appears, check whether the
batteries are properly inserted
(see 'Inserting the batteries').
3
Check whether all the keys are working.
For an overview of the keys and their
functions see '3. Keys and functions'.
–
If the TV responds as it should to all of the
key commands the RU530 is ready for use.
•
If the device does not respond at all or not to all of the
key commands, follow the instructions under
'Setting the remote control'.
4
TV
VCR
SAT
AV
PROG
VOL
VOL
PROG
Advertisement
Table of Contents
