HP iPAQ hx2000 Frequently Asked Questions Manual page 45

To manually add a wireless network:
1. Be sure Wi-Fi is powered on.
2. In the Navigation bar, tap the Connections icon (
Settings > Advanced tab > Select Networks button.
3. Enter or select the network name (or tap New) you want to
use to either connect to the Internet using an ISP or My Work
Network for work. Tap OK once completed.
4. Set up your Dialing Rules and Exceptions and press OK.
The next step is to set up your network interface cards.
5. From the iPAQ Wireless screen, tap (Wi-Fi) Settings.
6. Select Add New ... in the list box on the General tab to start
configuring wireless networks.
Note:
If a network is detected in step 3, the Security Set
Identifier (SSID) is automatically entered and cannot be changed.
7. Enter an SSID into the Network name box.
8. In the Connects to: box, select where your network connects
to (The Internet or Work).
9. If you want to connect to an ad-hoc connection, tap the This
is a device-to-device (ad-hoc) connection checkbox.
10. If authentication information is needed, from the Configure
Wireless Network screen, tap the Network Key tab.
Note:
To determine whether authentication information is
needed, see your network administrator.
11. To configure the type of network authentication to use, select:
a. To use Shared Key authentication, tap the
Authentication (Shared mode) listbox. Type the
network key in the Network Key: box.
b. To use data encryption, tap the Data encryption
(WEP enabled) listbox.
or ) >
41