HP iPAQ hx2000 Frequently Asked Questions Manual page 14

To synchronize your personal computer and your Pocket PC
using the autosync cable:
1. Be sure ActiveSync is installed on your personal computer.
Refer to
this document for more information.
2. Plug the AC Adapter into an electrical outlet, then connect
the other end of the AC Adapter to the AC connector on the
autosync cable.
3. Connect the 22-pin connector on the autosync cable to the
universal sync connector on the bottom of your iPAQ Pocket
PC.
Ä
CAUTION: To avoid damaging your Pocket PC or the autosync cable,
be sure the Pocket PC and cable connectors are properly aligned before
pushing the cable into the universal sync connector.
4. Connect the other end of the autosync cable to the USB port
on your computer. Synchronization begins automatically.
Ä
Note:
If you must log onto a server such as your company's
Virtual Private Network, you may receive a message from
ActiveSync telling you it is unable to synchronize. You must first
log onto the server for ActiveSync to synchronize.
If ActiveSync does not begin synchronizing, start it manually:
On your personal computer, open ActiveSync by clicking from
the Start menu > Programs > Microsoft ActiveSync > Sync.
Occasionally when attempting to synchronize to a personal
computer, you might receive an "Unable to Detect Device" error
message. This usually means your desktop cradle is not properly
connected to the synchronization cable, or your Pocket PC is not
seated firmly in the desktop cradle.
"How Do I Install Microsoft ActiveSync?" earlier in
10