Table of Contents
Advertisement
Chapter 2
Installing the Cisco Unified Videoconferencing 3545 Gateway
Related Topics
•
Mounting the Cisco Unified Videoconferencing 3545 Chassis in
a 19-inch Rack
You can optionally mount the Cisco Unified Videoconferencing 3545 chassis in a standard 19-inch rack.
Two mounting brackets and a set of screws are included in the Cisco Unified
Videoconferencing 3545 chassis shipping box.
Procedure
Disconnect all cables including the power cables.
Step 1
Place the Cisco Unified Videoconferencing 3545 chassis right-side up on a hard flat surface, with the
Step 2
front panel facing you.
Position a mounting bracket over the mounting holes on each side of the Cisco Unified
Step 3
Videoconferencing 3545 chassis, as shown in
Pass the screws through the brackets and tighten them into the screw holes on each side of the
Step 4
Cisco Unified Videoconferencing 3545 chassis using a suitable screwdriver.
Figure 2-4
Insert the Cisco Unified Videoconferencing 3545 chassis into the 19-inch rack.
Step 5
Fasten the brackets to the side rails of the rack.
Step 6
Make sure that the air vents at the sides of the Cisco Unified Videoconferencing 3545 chassis are not
Step 7
blocked.
Installation and Upgrade Guide for Cisco Unified Videoconferencing 3545 PRI Gateway and 3545 Serial Gateway Release 5.5
OL-14912-01
Serial Gateway Cable Connections and Pin-outs, page 2-15
Fitting a Bracket for Rack Mounting
Mounting the Cisco Unified Videoconferencing 3545 Chassis in a 19-inch Rack
Figure
2-4.
2-5
Advertisement
Table of Contents
