Table of Contents
Advertisement
3 Safety Rules
3.1 Safety rules
40
The lifting points are marked by the hazard warning
sign (1) on the machine.
The tie-down points are marked by the safety decal (2)
on the machine.
1
11
65
Moreover, the following instructions must be observed
while loading and tying down machines:
2
12
9602
(Fig. 11, 12)
3.1.21 Hydraulic system
Danger!
Hazard points on the machine.
Death or serious injury!
– Hazard warning signs / safety decals that
are damaged or unrecognisable must be
replaced immediately by new ones.
– When parts that have hazard warning
signs / safety decals are replaced, always
make sure to attach the relevant new haz-
ard warning signs / safety decals to
each new part.
1 Improper lifting or tying-down may relocate the
machine and cause injuries or damage.
2 Before bending or tying-down the machine, apply
the parking brake.
3 The feed rake conveyor must be fully raised
before bending or tying-down. Before standing
beneath the feed rake conveyor, its support fitted
to the raise cylinders must be installed.
4 For lifting the machine, use lift eyes and/or a car-
rying beam at the front. If such equipment is not
available, please contact your CLAAS dealer.
5 Use only flawless and sufficiently dimensioned lift-
ing devices for lifting the machine.
6 Protect your lifting device against sharp corners
and edges, e.g. by using edge protectors.
Danger!
Only have qualified workshops carry out repair
work on the hydraulic system.
00 0294 347 2 - BA LEXION 580R - 12/09
77353
5975
Advertisement
Table of Contents
