Cabling - ABB PowerValue 11 LI Pro 600 VA User Manual

64
—
1.4.2-1: Connect-
ing power to the
UPS 600-800 VA
—
1.4.2-2: Connecting
power to the UPS
1000-2000 VA
en
A B B U P S P R O D U C T S A N D S O L U T I O N S
1 .4 .2

Cabling

SOCKETS MARKED AS "SURGE ONLY" ARE ENERGIZED AS SOON AS THE AC INPUT IS APPLIED, EVEN IF
THE UPS IS NOT SWITCHED ON .
NOTE
1. Disconnect the power cord from the computer (rating 250Vac / 10A). Connect this cord to the male
input socket at the rear of the UPS and to a working, grounded AC wall socket outlet. The unit will
start automatically.
2. For best results, allow the UPS to recharge the batteries during a period of approx. 8 hours. It is
acceptable to use the UPS without first charging the battery, but the runtime may be reduced.
3. Plug your computer and monitor into the UPS "Battery backup & surge protection" sockets (see
figure 1.3.3-1 or 1.3.4-1). Through these sockets the UPS will provide emergency battery backup
power during a mains power failure as well as surge protection from surges and spikes.
CAUTION: DO NOT plug any LASER PRINTERS, 3-D PRINTERS and SURGE strip into any outlets.
4. Plug your peripheral equipment (traditional printer, scanner, fax, speaker, etc.) into the "Surge
only" outlets.
NOTE: Through these sockets the UPS will NOT provide battery backup power during a mains
power failure.
5. When the power LED (see figure 1.3.1-1 or 1.3.2-1) lights up, switch ON the connected equipment
6. Press the button next the LCD to power up the output load (see figure 1.3.1-1 or 1.3.2-1).
—
1.4.2-1
—
1.4.2-2