Tools Needed - Kobalt KMS 0724B-03 Manual

PREPARATION
PART DESCRIPTION
A Lock-off buttons
B On/Off switch
C LED switch
D Upper blade guard
E Dust-extraction port
F Depth-control knob
G Bevel-angle indicator
H Bevel scale
I Bevel-change lever
J Mounting holes (8)
K Saw base
L Miter table
M Miter scale
N Miter-angle indicator
O Saw blade
WARNING
• Do not allow familiarity with the miter saw to cause carelessness. Remember that one
careless moment is enough to cause severe injury. Before attempting to use any tool, be
sure to become familiar with all of the operating features and safety instructions.
• Do not attempt to modify this tool or create accessories not recommended for use with this
tool. Any such alteration or modification is misuse and could result in a hazardous condition
leading to possible serious personal injury.
• Use only a saw blade diameter in accordance with the markings on the saw and information
about the bore diameter and the maximum kerf of the saw blade. Use only saw blades that
are marked with a speed equal or higher than the speed marked on the tool.

TOOLS NEEDED

The following tools (not included) are needed for making adjustments or installation.
Phillips Screwdriver
2.5mm wrench
PART
P
Q
R
S
T
U
V
W
X
Y
Z
AA
AB
AC
AD
Adjustable Wrench
3mm wrench
11
DESCRIPTION
Miter-control lever
Lower blade guard
Main handle
Spindle-lock button
Fixed fence
Sliding fence (left and right)
Fence-lock knob (left and right)
Clamp receptacle (left and right)
45° bevel stop
33.9° bevel stop
Bevel-stop bolt
Bevel-lock knob
Sliding-lock knob
Arm-lock pin
Carrying handle
Combination square