ECOVACS DEEBOT T9 AIVI Instruction Manual page 19

No. Malfunction
DEEBOT returns to the Docking
4 Station before it has finished
cleaning.
DEEBOT does not clean
5 automatically at the scheduled
time.
DEEBOT is stuck when cleaning
6
with OZMO Pro installed.
DEEBOT misses cleaning
7 spots to be cleaned, or repeats
cleaning the area cleaned.
Possible Causes
Working time varies according to floor surface, room
complexity and the Cleaning Mode selected. When
the battery gets low, DEEBOT automatically switches
to Recharge Mode and returns to the Docking Station
to recharge itself.
DEEBOT is unable to reach certain areas blocked by
furniture or barriers.
The Docking Station is too distant from the center of
the house.
Time Scheduling function is cancelled.
DEEBOT is switched OFF.
The robot's battery is low.
DEEBOT may have difficulty climbing over obstacles
when using OZMO Pro.
The cleaning cycle is interfered by small objects or
barriers on the floor.
DEEBOT is working on slippery polished floors.
DEEBOT is unable to reach certain areas blocked by
furniture or barriers.
The TrueMapping Distance Sensor is blocked.
Solutions
Turn on Continuous Cleaning function in ECOVACS HOME App.
DEEBOT will automatically resume the uncompleted cleaning
cycle when Continuous Cleaning is enabled.
Tidy up the area to be cleaned by putting furniture and small
objects in their proper place.
Please place the Docking Station against the wall of a central
room of the house.
Program DEEBOT to clean at specific times using the ECOVACS
HOME App.
Switch ON DEEBOT.
Keep DEEBOT switched ON and connected to the Docking
Station to make sure it has a full battery to work at any time.
Please assist DEEBOT if there is a problem.
Remove power cords and small objects from the floor to ensure
cleaning efficiency. DEEBOT will automatically clean the area
missed, please avoid moving DEEBOT manually or block the path
during the cleaning cycle.
Make sure the floor wax is dried before DEEBOT starts cleaning.
Tidy up the area to be cleaned by putting furniture and small
objects in their proper place.
Remove the objects that are blocking the TrueMapping Distance
Sensor.
19
EN