The resolution settings to choose from are:
●
160 x 120 pixels
●
160 x 120 pixels
●
320 x 240 pixels
●
640 x 480 pixels
●
800 x 600 pixels
●
1600 x 1200 pixels (default)
NOTE
longer to send by Multimedia Messaging Service (MMS), e-mail, or infrared.
Changing the Flicker Filter
Fluorescent light bulbs flicker due to alternating current. The electronic shutter on the camera is not
immune to this flickering. Use the Flicker Filter setting to filter out flickering, sometimes called banding.
1.
From the camera interface, tap the Options button > Settings tab > Flicker Filter > Change
button.
2.
Make the necessary changes, and then tap OK.
NOTE
The flicker filter settings to choose from are:
●
50 Hz - filters banding caused by fluorescent light bulbs operating on an alternating current at 50
Hz
●
60 Hz - filters banding caused by fluorescent light bulbs operating on an alternating current at 60
Hz
Turning Camera Sounds On and Off
1.
From the camera interface, tap the Options button > Setup tab > Camera Sounds > Change
button.
2.
Tap either On or Off.
3.
Tap OK.
Configuring Instant Review
Instant Review determines how long an image is available after it is captured.
1.
From the camera interface, tap the Options button > Setup tab > Instant Review > Change button.
2.
Tap either Off, 2, 4, or 6 seconds.
3.
Tap OK.
ENWW
The larger the resolution you choose, the more storage space required and it may take
To reset the camera settings, tap the Reset button.
Changing Camera Settings
55