Step 2: Install The Battery And Replace The Battery Cover; Step 3: Charge The Battery - HP iPAQ 510 Product Manual

Step 2: Install the battery and replace the battery cover

1. Align the battery connectors on the battery with the housing pins in the battery compartment, and
insert the battery.
2. Place the battery cover down and slide up until it clicks into place.

Step 3: Charge the battery

CAUTION:
aligned before connecting.
The battery provides power for your HP iPAQ to operate. Your HP iPAQ comes with a mini-USB
synchronization cable, which must be used to charge the device.
It takes approximately 2–4 hours to fully charge the battery for the first time. Subsequent charges may
take longer.
1. Insert the USB end of the mini-USB synchronization cable into the port on the AC adapter.
2. Connect the AC adapter to an electrical outlet.
3. Connect the mini-USB synchronization cable to the charging/communications port on your
HP iPAQ. The cable connector only fits one way. If the connector does not insert easily, turn it over.
To avoid damaging your HP iPAQ or the AC adapter, Make sure all connectors are properly
Step 2: Install the battery and replace the battery cover 7