Step 4: Turn On Your Hp Ipaq; Protecting Your Hp Ipaq With A Password; Finding The Serial And Model Number; Status Icons - HP iPAQ 510 Product Manual

TIP: You can also charge the battery by connecting your HP iPAQ to a USB port on your computer
using the mini-USB synchronization cable.
NOTE:
least two seconds. In case the device does not switch on, attach an AC adapter to switch on your
HP iPAQ.

Step 4: Turn on your HP iPAQ

Press the Power button or End key to turn on your HP iPAQ. Next, follow the instructions on the screen
to complete the setup. Use the keypad to enter information.

Protecting Your HP iPAQ with a Password

You can secure the data on your HP iPAQ by setting a password. Each time you turn on your HP iPAQ,
you will be prompted to enter the password.
To set a password:
1. Press Start > Settings > Security > Device Lock.
2. Select the Prompt if device unused for check box, and select the time that your HP iPAQ must
be unused before you are prompted for a password.
3. In the Password type box, select the type of password you would like to use. Enter the password
and then confirm the password.
4. Press Done.
The next time your HP iPAQ is unused for the specified period of time, you are prompted to enter your
password.
TIP: Use the same steps as above to change or reset your password.

Finding the Serial and Model Number

Locate the serial and model number of your HP iPAQ before contacting HP Customer Support,
particularly if you are calling for in-warranty support.
View the serial and model ID by pressing Start > More > HP Help and Support > Serial and Model
Number.
You can also find this information below the battery of your HP iPAQ:
To locate the serial and model number:
1. Remove the battery cover.
2. Remove the battery from the unit.
3. Locate the label containing the product ID and serial number underneath the battery.

Status Icons

The following table lists the common status indicators and their meanings.
8 Chapter 4 Setting Up Your HP iPAQ
Whenever a replacement battery is inserted into your HP iPAQ, press the End key for at