Cisco 10BASE-FL Installation And Configuration Manual page 10

What Is the 5EFL Port Adapter?
Figure 4
Port adapter slot 5
Port adapter slot 3
Port adapter slot 1
5EFL Port Adapter LEDs
The 5EFL port adapter contains the enabled LED, standard on all port adapters, and one status LED
for each port, called the link LED. After system initialization, the enabled LED goes on to indicate
that the 5EFL port adapter has been enabled for operation. (The LEDs are shown in Figure 5.)
Figure 5
The following conditions must be met before the enabled LED goes on:
•
•
•
If any of these conditions is not met, or if the initialization fails for other reasons, the enabled LED
does not go on. When a 10BASE-FL port is active, its link LED is on when the 5EFL port adapter
is receiving a carrier signal from the network.
10 PA-5EFL Ethernet 10BASE-FL Port Adapter Installation and Configuration
Port Adapters in the Cisco 7206
LEDs on the 5EFL Port Adapter, Partial Faceplate View
The 5EFL interface is correctly connected and receiving power
The 5EFL-equipped card or chassis contains a valid microcode version that has been downloaded
successfully
The bus recognizes the 5EFL port adapter or 5EFL-equipped VIP2
Blank port adapter
ETHERNET 10BT
Port adapter slot 0
PACKET OVER SONET/SDH
Port adapter slot 6
Port adapter slot 4
Port adapter slot 2
TOKEN RING
ETHERNET-10BFL
FAST ETHERNET INPUT/OUTPUT CONTROLLER