Installation Built-In - Stanley Argon NMARWH90 Manual

INSTALLATION- BUILT-IN
1. Select a location that is not prone to
moisture and is located at least 0.91m or
3 feet away from combustible materials
such as curtains or drapes, furniture,
bedding, paper, etc.
2. Mark the desired location on the floor
and store appliance in a safe, dry and
dust free location.
3. Prepare a wall with a framed opening to
accommodate the size of your unit.
Leave at least 1/4" (6 mm) around the
edge of the appliance. Any new wiring
must be done in compliance with local
and national codes and other applicable
regulations.
Note: Fireplace must stick out of the wall a
minimum of 2 1/4" or 5.8 cm.
Prior to installing the appliance, test to
make sure the
properly by plugging the power supply
cord into a conveniently located 240 Volt
grounded outlet.
The rough wall opening size of the fireplace.
W
NMARWH90 27"/ 68.58cm
NMARWH110 35"/ 88.9cm
NMARWH140 49"/ 124.46cm
appliance operates
D H
5"/ 12.7cm 22"/ 55.88cm
5"/ 12.7cm 22"/ 55.88cm
5"/ 12.7cm 22"/ 55.88cm
1.
Take the front glass off from the unit. Put the
brackets on the both sides and top of the fireplace
as shown blew.
2. Lift fireplace and insert into opening.
3. Make sure that the power supply port is
not behind the wall.
4. Level the fireplace.
5. Drive mounting
mounting brackets on the unit and the
wall studs.
9
screws into the