Trouble Shooting - Stanley Argon NMARWH90 Manual

TRUBLE SHOOTING
PROBLEM
Dim or no flame
Ember bed is not
glowing or dimming
Appliance turns
and will not turn on
Appliance will not
come on when switch
is flipped to ON
No warm air coming
out of appliance
Flame sputters
Remote Control does
not work.
Flame is fixed.
POSIBBLE CAUSE
Flame LED's are burnt out
Ember LED's are burnt out
off Appliance has
and safety device has caused
the thermal
disconnect
House circuit breaker has
tripped
Appliance's fuse has blown
Appliance is not plugged into
an electrical outlet
Appliance has
and safety device has caused
the thermal
disconnect
Circuit board is burnt out
Heater is burnt out
Flame motor is defective.
Low batteries.
Unit switch in "O" position.
Wiring may be loose or the
flame motor may be defective.
SOLUTION
Inspect the LED's and replace
them if necessary.
Inspect the ember bed LED's and
replace them if necessary.
overheated Turn off the main switch, allow
appliance to cool for 10 minutes,
switch to then turn it on.
Reset house circuit breaker.
Replace the fuse.
Check plug and plug in.
overheated Turn off the main switch, allow
appliance to cool for 10 minutes,
switch to then turn it on.
Inspect the circuit board and
replace it if necessary.
Inspect the burner and heater
assembly
necessary.
Call a qualified service technician
and replace flame motor.
Replace AAA batteries in remote
control.
Turn the switch in "I" position.
20
and replace it if