Summary of Contents for Stanley Argon Built In ARBI100
Page 1
PLEASE RETAIN Argon Built In MODELS: ARBI100/ARBI130 INSTALLATION AND OPERATING INSTRUCTIONS The complete installation must be done in accordance with current Standards and Local Codes. The instructions in this manual must be followed to ensure safe operation of the appliance. It should be noted that the requirements and this publication may be superseded during the life of the stove.
CONDITIONS OF WARRANTY Your Stanley Appliance is guaranteed against any part that fails (under normal operating conditions) for a two year peri- od from the date of installation of the appliance. If the unit is not installed within six months of date of purchase, the warranty will commence six months from the date of purchase.
IMPORTANT OPERATION / MAINTENANCE NOTES Now that your Stanley Appliance is installed and no doubt you are looking forward to the many comforts it will provide, we would like to give you some tips on how to get the best results from your unit.
13 Table 1: Approx Wall Opening Sizes amp grounded socket. accomodate the size of the of the unit (refer Your Stanley Appliance is supplied with the following to Table 1). items: • Four Sided Frame Remove the four sided frame (see Fig 2).
Fig 3 Fig 4 MOUNTING BRACKET Level the unit and secure in position by fitting the mounting brackets to the wall stud using the screws provided. Refit the Four Sided Frame. PRODUCT DIMENSIONS ARBI100 Fig 5...
ARBI130 Fig 6 Note: Dimensions stated are in millimetres unless otherwise stated and may be subject to a slight +/- variation. TECHNICAL DATA ARBI100 ARBI130 Voltage 240V AC 50-60 Hz Max Power 2000W No Heater Motor Heater Gross Weight (kgs): Efficiency Rating: COMMISSIONING AND HANDOVER On completion of the installation:...
MANUAL OPERATION Heater Operation Flame Operation Press the Heater Button once to activate the heater Press the Flame Button and the flame picture will be at full output (2kW) and the Heater Indicator will illu- at maximum brightness. Press the Flame Button minate red.
Heater Operation Fig 7 Press the Power Button to turn on the remote control. The Screen will illuminate, the flame MAX HEAT INDICATOR picture on the unit illuminates and the Flame Picture Icon will appear on the remote control screen. Press the Heater Button once to activate the heater at full output (2kW).
Fig 10 Press the Timer Setting button and the remote screen will be as shown in Fig 9 with the temperature setting flashing. Adjust the temperature setting by pressing the Adjust + and Adjust - buttons. Press the Shift Key to enter the time parameters for Monday (1).
CLEANING SAFETY CUT-OUT NOTE: Allow the product to completely This appliance is fitted with a safety cut-out which cool before handling or cleaning it. will operate if the unit overheats (i.e. due to blocked air vents). For safety reasons, the unit will not auto- Switch off and unplug from the power supply matically reset.